1 Series E81 130i (N52K) 3-door
37 14 512
Replacing rear ride-height sensor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Note:
Jointed rod to camber arm holder 37 14 3AZ
.
Release nut (1) and disconnect jointed rod (2).
Installation:
Tightening torque 37 14 3AZ
.
Disconnect plug connection (3).
Release bolt (4) and remove ride-height sensor with bracket.
Installation:
Align bracket to corresponding bore hole (arrow) in rear axle
carrier.
Tightening torque 37 14 2AZ
.
Replacement:
Release screws (1) and remove ride-height sensor from
bracket (2).
Installation:
Sensor lever (3) must point from ride-height sensor in direction of
screw fastening point (arrow) of bracket.
Tightening torque 37 14 1AZ
.
RA Replacing rear ride-height sensor
BMW AG - TIS
22.01.2013 06:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
