1 Series E81 130i (N52K) 3-door
41 00 ...
Vehicle identification number, general
The vehicle identification number must be stamped with a special tool. There are different special tool numbers and
stamping procedures for the various vehicles. Refer to the relevant repair instructions.
In repair work, the vehicle identification number is always stamped into a replacement vehicle identification number
surface.The replacement surface is usually situated under the original VIN surface.
The IGEF number (bodyshell number) is omitted when the wheel arch is replaced.
In the event of component or body replacement by the BMW garages/workshops, clearly delimit the vehicle
identification number at front and rear by stamping a + in place of the BMW emblem.
If a VIN is stamped into the replacement surface in addition to the original VIN (e.g. if the original VIN has been
tampered with), the following applies: The original VIN must be crossed out. To do so, stamp the letter I from the punch
digits lengthways through the original VIN.
Important!
Do not use an angle grinder in conjunction with a cutting disk!
The protective film used as standard is omitted after the VIN has been manually stamped in. Paint area in accordance
with BMW Painting Handbook. Ensure that layer thicknesses are small.
Observe country-specific regulations.
RA Vehicle identification number, general
BMW AG - TIS
22.01.2013 06:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
