1 Series E81 130i (N52K) 3-door
Drill holes (1) and (2) at distance of 25 mm to each other.
Hole diameter approx. 8 mm.
Make reinforcement plate (1) from trim of new part.
If necessary, make further reinforcement plates.
Length of reinforcement plates is min. 40 mm.
Coat reinforcement plates (1) and (2) on both sides with welding
primer.
Push reinforcement plate (1) into component on body up to half
way and plug-weld (3).
If necessary, adjust new part (1) to fit with straightening
attachment or universal mount and plug-weld (2).
MAG weld joint (3).
Grind and clean weld seam and plug weld spots.
Only visible areas of the outer skin and worn areas on the support
carrier must be tinned.
All areas which have covers on the vehicle are not to be tinned.
Note:
Only applicable within the European Union!
European used-car regulations prohibit the use of tin containing
lead in motor vehicles introduced after 01.07.2003!
RA Welding in reinforcement plate (steel plate)
BMW AG - TIS
22.01.2013 06:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -