1 Series E81 130i (N52K) 3-door
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in areas (1) and (2).
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in area (1).
Installation:
Weld new component in areas (2) additionally.
Open weld joints in area (1).
Preparation of new part:
Carry over the work step shown symmetrically to the other side of
the vehicle.
Mark severance cuts (1) in accordance with measurement and
cut.
Important!
Cut outer metal sheet only.
Measurement a=170 mm
Measurement b = 110 mm
Installation:
The parts separated by cutting are still needed.
Weld in reinforcement plates at severance cuts.
RA Replacing luggage compartment floor (complete with both inner wheel arch section
BMW AG - TIS
22.01.2013 06:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
