1 Series E81 130i (N52K) 3-door
41 14 502
Replacing rear left outer wheel arch section
(rear left side panel removed)
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 14 502).
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Use only approved spot-welding apparatus for repairs!
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) Inner side frame
-
(2) Rear entrance shaped part (not shown)
Mark severance cut in accordance with specified measurement
and cut.
Important!
Cut outer metal sheet only.
Measurement a = approx. 100 mm from centre of 25 mm dia.
holes
Open weld joints in area (1).
Installation:
Weld in reinforcement plate at severance cut.
Open weld joints in area (1).
RA Replacing rear left outer wheel arch section (rear left side panel removed)
BMW AG - TIS
22.01.2013 06:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
