1 Series E81 130i (N52K) 3-door
51 31 ...
Removing and installing/replacing retaining
strip for cowl panel cover
Necessary preliminary tasks:
•
Remove cover for cowl panel
Important!
Retaining strip (2) has an aluminium profile insert (1).
Carefully wind out retaining strip (2) (windscreen breakage).
4
Glue bead
5
Pinched butyl
6
Contact surfaces
Installation:
Clean cutout.
Pay attention to centre marking on retaining strip (1) and
windscreen.
Insert positioner (2) for retaining strip (1) must be removed after
it has been fitted on the windscreen but before the windscreen
itself is installed.
Replacement of retaining strip without windscreen removal:
If adhesive has managed to get onto retaining strip (1), this area
must be cut out partially.
To facilitate installation, coat and body cutout with water.
Replacement of retaining strip with removed or new windscreen:
Fit rubber frame (1).
3
Aluminum strip
4
Contact surfaces
5
Butyl
RA Removing and installing/replacing retaining strip for cowl panel cover
BMW AG - TIS
22.01.2013 07:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
