1 Series E81 130i (N52K) 3-door
61 00 ...
Notes on handling optical fibers
Caution!
To avoid damage when handling optical fibers, comply with
the following points:
•
The minimum permitted bending radius is 25 mm
•
Do not subject optical fibers to compressive and tensile load
•
Protect optical fibers against the effects of heat
≥
85
°
C (e.g.
during welding work, drying work with infrared heater or hot
air blower)
•
Optical fibers are permitted to show only one junction point
(bridge), replace optical fibers if necessary
Note:
The optical fibers are colored differently as follows:
•
Green=MOST (Media Oriented Systems Transport) optical
fibers
•
Yellow=ISIS (Intelligent Safety and Integration System) optical
fibers
•
Orange=repair optical fibers
Follow instructions for processing cables and optical fibers.
RA Notes on handling optical fibers
BMW AG - TIS
22.01.2013 08:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
