1 Series E81 130i (N52K) 3-door
61 61 270
Removing and installing or replacing bracket
for windscreen wiper system complete with
motor
Necessary preliminary tasks:
•
Remove cowl panel cover
•
Remove both tension struts from spring strut dome
Release screws (2) from left heater bulkhead (3).
Remove left heater bulkhead (3) towards top.
Unclip cable (1) for wiper motor from holder.
Release screws (5) for wiper bracket (4).
Tightening torque 61 61 6AZ
.
Remove wiper bracket (4) upwards.
Disconnect plug for wiper motor.
Installation:
Before fitting the wiper arms, allow the windscreen wiper motor to
run into the rest position.
To ensure that the windscreen wiper system functions properly,
check/adjust the contact angle of the wiper arms to the
windscreen.
RA Removing and installing or replacing bracket for windscreen wiper system complet
BMW AG - TIS
22.01.2013 09:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
