1 Series E81 130i (N52K) 3-door
Unclip Omega cable holder (1) from seat mechanism (2).
Unscrew nuts (1).
Installation:
Replace nuts.
Tightening torques 72 12 02AZ
.
Important!
Feed the wiring harness carefully through the seat and
backrest mechanism as the edges of the frame can be sharp.
Pull airbag module (2) with threaded pins out of backrest frame.
Feed out airbag module (2) between padding (1) and inner
bag (3).
Installation:
Pull inner bag (3) fully over airbag module (2) and threaded
pins.
Insert threaded pins into backrest frame and secure with new
nuts.
No inner bag material is permitted to project through the hole in
the inner frame.
Install nuts and tighten down.
Tightening torques 72 12 02AZ
.
RA Removing and installing side airbag (basic seat)
BMW AG - TIS
22.01.2013 10:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
