1 Series 123d (N47S) Coupe
Position special tool 00 2 530 with dial gauge (1) on valve.
Determine valve recess.
Check dowel sleeves (1) for damage and correct installation
position.
Clean sealing faces with suitable tool.
Important!
There must be no coolant, water and engine oil in any of the
threaded holes in the engine block.
Fit new cylinder head screws.
Do not wash off bolt coating.
Joining torque and angle of rotation must be observed without
fail (risk of damage!).
Fit new cylinder head gasket with previously determined gasket
thickness (number of holes).
Fit cylinder head and secure with new bolts, tightening in the
sequence 1 to 10.
Tightening torque: 11 12 1AZ
.
RA Removing and cylinder head (N47, N47S)
BMW AG - TIS
16.01.2013 01:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
