1 Series 123d (N47S) Coupe
17 11 046
Removing and installing / replacing module
carrier
Necessary preliminary tasks:
•
Remove coolant cooler
•
If necessary, slacken power steering cooling coil; refer to
Removing power steering cooling coil
•
If necessary, slacken A/C condenser and secure against
damage and against falling down. Refer to Remove A/C
condenser.
Release damping pieces.
Press lock (1) and remove holder (2) downwards.
Illustration shows the left holder: The same procedure applies to
the opposite side.
Installation:
Rubber mounts fall out easily, ensure correct installation position.
S65 only: Engine oil cooler loose, see Removing oil cooler.
Remove module carrier (1) individually towards bottom.
RA Removing and installing / replacing module carrier
BMW AG - TIS
16.01.2013 03:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
