1 Series 123d (N47S) Coupe
Installation:
Check dowel sleeves (1 and 2) for correct seating.
Replace damaged sleeves.
Ensure correct position of cover plate.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, clean input shaft and replace
clutch plate.
.
Check clutch plate for friction rust in splines and replace if
necessary.
Remove any grease and lining abrasion from splines of clutch
plate by mechanical means (with a cloth).
Installation:
Greasing specification:
-
Remove and clean release bearing and release lever (do not
grease).
-
Push on grease scraper ring 21 2 221 as far as it will go.
-
Grease splines (1) of input shaft with a brush.
-
Refer to BMW Service Operating Fluids
-
Detach grease scraper ring.
RA Removing and installing transmission (GS6-17BZ) N51/N52/N52K/N53
BMW AG - TIS
16.01.2013 04:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
