1 Series 123d (N47S) Coupe
Installation:
Adjust new parts to fit with straightening attachment or universal
mount.
Before welding in, also adjust tail panel, rear lid and rear lights to
fit.
Weld new components in following order:
-
(1) Rear axle carrier
-
(2) Luggage compartment floor, upper section
-
(3) Support, frame side member
-
(4) Wheel arch, rear, inner half
Installation:
For reasons of accessibility, the repair joining sequence differs
from the standard joining sequence.
Fit new component from above in area (1), adjust to fit and weld.
RA Replacing luggage compartment floor (complete with both inner wheel arch section
BMW AG - TIS
16.01.2013 07:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
