1 Series 123d (N47S) Coupe
41 21 930
Replacing inside left side frame (B-pillar
reinforcement)
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 21 930).
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Side panel removed.
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) B-pillar, inner
-
(2) Shaped part, B-pillar, inner
-
(3) Shaped part, B-pillar, bottom outer
-
(4) Shaped part, B-pillar, side
Mark severance cut (1) in accordance with measurement and cut.
Important!
Cut outer metal sheet only.
Measurement a = approx. 5 mm.
Open weld joints in areas (2).
Remove side panel metal section (3).
Mark severance cut (1) and cut.
Important!
Cut outer metal sheet only.
Open weld joints in areas (2).
RA Replacing inside left side frame (B-pillar reinforcement)
BMW AG - TIS
16.01.2013 07:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
