1 Series 123d (N47S) Coupe
Release screws (1) on bumper trim (2).
Important!
Risk of damage!
Do not detach bumper trim (1) at sides
The following work must be carried out with a second person
assisting:
Note:
Picture shows E92.
Pull bumper trim (1) towards rear and release from catches (2).
Press down catch (2).
Remove bumper trim (1) towards rear with aid of a 2nd person.
If necessary, disconnect plug connection on ultrasonic
transducers.
Installation:
Catches (1) and guides (2) must not be damaged.
If necessary, replace faulty sheet nuts (3) on left/right.
Replacement:
•
If necessary, modify ultrasonic transducer
•
Modify towing eye cover
RA Removing and installing/replacing rear bumper trim
BMW AG - TIS
16.01.2013 08:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
