1 Series 123d (N47S) Coupe
Lever cover with trim wires (1) out of metal claws (2) all round
from skibag opening.
Remove backrest cover with padding from carrier section.
Detaching cover and padding:
•
Release all retainers in marked area
•
Remove cover from padding
•
Remove remaining retainers from cover and padding
Installation:
Insert new retainer (2) with special tool 52 0 050 .
In so doing, enclose wire in padding and trim wire of cover and
bend closed.
1.
Padding
2.
Retainer
3.
Trim wire in padding
4.
Trim wire in seat cover
5.
Seat cover
Replacing cover:
•
Remove all trim wires from cover
•
If necessary, cut pockets in new cover for trim wires
•
Push trim wires into cover pockets
RA Replacing left backrest cover for rear seat
BMW AG - TIS
17.01.2013 01:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -