1 Series 123d (N47S) Coupe
65 75 071
Removing and installing (replacing) module
for passenger compartment sensor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove complete ceiling light (rear)
Open retaining shook (1) in direction of arrow and remove
module for passenger compartment sensor (2) from trim (3).
Installation:
Retaining hooks (1) must not be damaged.
Arrow (4) must point in opposite direction to direction of travel.
Replacement:
Carry out programming/coding.
RA Removing and installing (replacing) module for passenger compartment sensor
BMW AG - TIS
17.01.2013 04:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -