1 Series 135is (N54) Coupe
34 21 320
Removing and installing or replacing both
rear brake discs
Special tools required:
•
34 1 280
Necessary preliminary tasks:
•
Remove wheels
After completing work:
•
Adjust handbrake
•
Read and comply with notes on braking in new brake discs /
brake pads.
Check minimum brake disc thickness:
-
Position special tool 34 1 280 at three measuring points in
area (1) and measure.
-
Compare measurement result and lowest value with setpoint
value.
New brake pads may only be installed if the brake disc thickness
is greater than or equal to the minimum brake disc thickness (MIN
TH).
If the brake discs are replaced, you must also fit new brake pads.
Always replace brake discs in pairs.
Release bolts (1) and pull off brake caliper towards front.
Important!
Tie brake caliper back and do not allow to hang from brake
hose.
Installation:
Tightening torque 34 21 2AZ
.
RA Removing and installing or replacing both rear brake discs
BMW AG - TIS
18.01.2013 09:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -