1 Series E87 116i (N45T) 5-door
11 36 655
Removing and installing/replacing both
solenoid valves (N45T)
Necessary preliminary tasks:
•
Remove intake duct
Unlock plug of solenoid valves (1 and 2) and disconnect.
Release screws and remove holder (3).
Pull out solenoid valves (1 and 2).
Note:
Solenoid valve (1) controls adjustment unit on exhaust side.
Solenoid valve (2) controls adjustment unit on inlet side.
Installation:
Check holder (3) for deformation; replace if necessary.
Installation:
Clean sealing faces (1) on cylinder head.
Installation:
Replace O-rings (1 and 2) on solenoid valve (3).
RA Removing and installing/replacing both solenoid valves (N45T)
BMW AG - TIS
17.01.2013 15:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
