1 Series E87 116i (N45T) 5-door
Crank engine at vibration damper in direction of rotation until
screw (1) is visible in opening.
Release all screws of torque converter with special tool
24 1 110 .
Crank engine further and release remaining 5 bolts.
Tightening torque 24 40 1AZ
.
Prepare special tool (1) 24 4 161 with shaped piece (2)
24 4 165 .
Insert special tool 24 4 160 into opening of transmission
housing and tighten down slightly with screw (1).
•
Unlock and disconnect plug (1) by turning.
•
Do not touch pins.
•
Release cable from retainers.
•
Insert special tool 24 2 390 in sealing sleeve.
Operations are described in
Note on mechatronics
Important!
Read and comply with important note.
RA Removing and installing automatic transmission (GA6L45R) N45T, N46T
BMW AG - TIS
17.01.2013 16:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -