bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Replacing Luggage Compartment Floor (complete With Both Inner Wheel Arch Section|Page 1381 > < 2 RA Replacing Luggage Compartment Floor (complete With Both Inner Wheel Arch Section
Page 2
background image

Carry over the work step shown symmetrically to the other side of
the vehicle.

Mark severance cut (1) and cut.

Open weld joints in areas (2).

Installation:

Weld new components in areas (3) additionally.

Carry over the work step shown symmetrically to the other side of
the vehicle.

Mark severance cut (1) in accordance with measurement a and
cut rear axle carrier.

Important!

Cut outer metal sheet only.

Measurement a=70 mm from rear axle bushing mounting.

Open weld joints in area (2).

Installation:

Weld in reinforcement plates at severance cuts.

Carry over the work step shown symmetrically to the other side of
the vehicle.

Open weld joints in area (1).

Installation:

Weld new components in area (2) additionally.

Coupé only:

Carry over the work step shown symmetrically to the other side of
the vehicle.

Open weld joints in area (1).

Installation:

Weld new components in area (2) additionally.

RA  Replacing luggage compartment floor (complete with both inner wheel arch section

BMW AG - TIS

17.01.2013  18:41

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

2 RA Replacing Luggage Compartment Floor (complete With Both Inner Wheel Arch Section|Page 1381 > < 2 RA Replacing Luggage Compartment Floor (complete With Both Inner Wheel Arch Section