1 Series E87 118d (M47T2) 5-door
11 14 151
Replacing crankshaft radial seal (M47TU /
M47TU2)
(Transmission side)
Remove transmission.
Drain engine oil.
Remove flywheel.
Unfasten oil sump screws on transmission end.
Loosen oil pan.
Release screws in end cover at rear.
Carefully detach oil sump gasket from end cover, remove end
cover.
Note:
Check sump gasket for damage after removing end cover.
If necessary, remove oil sump and replace oil sump gasket.
RA Replacing crankshaft radial seal (M47TU / M47TU2)
BMW AG - TIS
18.01.2013 08:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
