1 Series E87 118d (M47T2) 5-door
11 22 513
Replacing roller bearing for dual-mass
flywheel
Special tools required:
•
21 2 051
•
21 2 052
Note:
Flywheel removed!
Using hydraulic press (1) and special tool 21 2 051 , press out
dual-mass flywheel downwards on engine side.
Important!
Risk of damage:
Roller bearing must not be driven out.
Push roller bearing (2) onto special tool 21 2 052 .
Using hydraulic press (1), press roller bearing into dual-mass
flywheel as far as it will go on clutch side.
Important!
Risk of damage:
Observe press-in instruction:
-
Roller bearing must not be driven in.
-
Roller bearing mounting force/travel monitored:
Min. 2000N 1 mm before end of pressing in.
RA Replacing roller bearing for dual-mass flywheel
BMW AG - TIS
18.01.2013 08:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
