1 Series E87 118d (M47T2) 5-door
Important!
No piston is permitted to be in the TDC position risk of
damage.
Crank engine back at crankshaft through 45
°
.
Turn exhaust camshaft at hexagon head in direction of arrow.
The hydraulic chain tensioner can be secured in place in this
position with special tool 11 3 340 .
Note:
The hydraulic chain tension is forced back by rotating the exhaust
and inlet camshafts.
Lock hydraulic chain tensioner with special tool 11 3 340 .
Note:
If the sprocket wheel is removed without the hydraulic chain
tensioner being locked, the chain tensioner piston will slip out
and can then only be pressed back again with a considerable
amount of effort.
Remove protective cap in direction of arrow.
Installation:
Reinstall protective cap with some grease.
Crank engine at crankshaft with special tool 11 6 480 .
Secure crankshaft at flywheel with special tool 11 5 180 .
RA Replacing camshafts (M47T2)
BMW AG - TIS
18.01.2013 08:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
