1 Series E87 118d (M47T2) 5-door
16 11 030
Removing and installing or replacing fuel tank
(diesel)
Recycling
Fuel escapes when fuel lines are detached. Have a suitable
collecting container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
Important!
Ensure adequate ventilation in the place of work!
After installation of fuel tank/prior to first engine start-up:
•
Check ground connection at fuel filler neck to body for
continuity. If necessary, clean contact surface between
body and fuel filler pipe screw connection.
•
Fill fuel tank with min. 5 l fuel.
•
Check transfer function of suction jet pump.
Necessary preliminary tasks:
•
Draw off fuel from fuel tank
•
Remove rear seat bench
•
Remove guide tube for handbrake cables
•
Remove right wheel arch trim
•
Remove rear left and right underbody panelling
•
Remove left and right underbody cover
Release screws (1) and remove cover (2) from left and right
sides of fuel tank.
RA Removing and installing or replacing fuel tank (diesel)
BMW AG - TIS
18.01.2013 08:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -