1 Series E87 118d (M47T2) 5-door
32 11 ...
Replacing gaiter for electric steering gear
(EPS) on left or right
Spindle side:
Important!
The steering gear must be replaced If the corrosion on the
spindle running surface has advanced to such an extent that
the steering is acoustically conspicuous under load!
Adhere to the utmost cleanliness.
Do not regrease the spindle running surface. Sufficient special
grease was used during assembly for lifetime filling.
Rack side:
Important!
The steering gear must be replaced if the polished surface of
the rack is damaged (e.g. by corrosion)!
Clean rack and check surface for damage (e.g. by corrosion).
Grease rack (refer to BMW Service Operating Fluids).
Necessary preliminary tasks:
•
Remove front assembly underside protection
Clean tie rod.
Release band clamp (1).
Mark screw-in depth of tie rod (2) or count thread turns.
Unscrew bolt (3).
Twist tie rod (2) out of tie rod end (4).
Installation:
Replace microencapsulated screw.
Tightening torque 32 21 2AZ
.
RA Replacing gaiter for electric steering gear (EPS) on left or right
BMW AG - TIS
18.01.2013 09:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
