1 Series E87 118d (M47T2) 5-door
Installing inner gaiter:
Push gaiter with cap onto output shaft (1).
Mount special tool 33 2 100 with corresponding shell inserts on
output shaft (1).
Press joint (2) over bearing inner race onto output shaft.
Install new circlip (1).
Important!
Keep sealing faces of cap and joint (on both sides) clean and
free from grease.
Fill joint at both ends with high-temperature grease.
Important!
Risk of damage!
Do not install gaiter with cap and sealing cover on joint without
shims.
RA Replacing gaiter on left output shaft (altered sealing cover)
BMW AG - TIS
18.01.2013 10:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
