1 Series E87 118d (M47T2) 5-door
Align rubber mount by way of slot to marking on rear axle carrier.
Draw rubber mount a little into rear axle carrier with special tools
33 4 471 , 33 4 474 , 33 4 475 , 33 4 466 and 33 4 465 .
Remove special tool 33 4 450 .
Apply a thin coating of Loctite 638 to new rubber mount.
Draw in rubber mount as far as it will go.
After installation:
•
Carry out wheel/chassis alignment check
RA Replacing a rubber mount for trailing arm in rear axle carrier
BMW AG - TIS
18.01.2013 10:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
