1 Series E87 118d (M47T2) 5-door
33 32 071
Replacing one upper control arm
Note:
If the control arm is detached from the rear axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel
Release screw (1).
Installation:
If necessary, raise brake disk in drive flange area with workshop
jack.
Replace screw.
Tightening torque 33 32 6AZ
.
Important!
Make sure during installation that in the connection area to the
wheel carrier the tapered end of the bearing bushing (of the
rubber mount) points in the direction of the wheel carrier.
RA Replacing one upper control arm
BMW AG - TIS
18.01.2013 10:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
