1 Series E87 118d (M47T2) 5-door
Pull brake pad wear sensor (1) towards rear out of lining (left side
only).
Release guide screw (2).
If necessary, grip at hexagon head (3).
Tilt brake caliper upwards.
Installation:
Replace guide screws.
Tightening torque 34 11 5AZ
.
Remove brake pads (1) in direction of arrow from brake console.
Important!
Mark any worn brake pads.
In the event of one-sided brake pad wear, do not change
brake pads round.
Observe minimum thickness of brake pads.
Clean brake pads.
Do not apply grease to brake pad backplate.
Check minimum brake disc thickness:
-
Position special tool 34 1 280 at three measuring points in
area (1) and measure.
-
Compare measurement result and lowest value with setpoint
value.
New brake pads may only be installed if the brake disc thickness
is greater than or equal to the minimum brake disc thickness (MIN
TH).
Note:
The minimum thickness of the brake disc is designed so that it
holds over the service life of a further set of brake pads if it is
greater than or equal to the minimum brake disc thickness (MIN
TH).
Press brake piston fully back with special tool 34 1 050 .
Important!
When pressing piston back, note brake fluid level in
expansion tank.
Overflowing brake fluid will damage the paintwork.
RA Removing and installing or replacing brake pads on both front disc brakes (TRW f
BMW AG - TIS
18.01.2013 10:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
