1 Series E87 118d (M47T2) 5-door
Release screws (1), remove brake calliper (2) with brake console
(3) and tie back.
Installation:
Tightening torque 34 11 2AZ
.
Check that brake hose is correctly seated in holder.
Important!
To release brake disc: Do not under any circumstances strike
friction ring with a hammer or similar!
If necessary, carefully tap on base of brake disc chamber with
a rubber mallet.
Clean contact surface of brake disc at wheel hub thoroughly
and remove traces of corrosion.
Unevenness on contact surface may result in distortion of
brake disc!
Release screw (1) and remove brake disc (2).
Installation:
Replace screw.
Tightening torque 34 11 1AZ
.
After installation:
•
Read and comply with notes on braking in new brake discs /
brake pads.
RA Removing and installing or replacing both front brake discs
BMW AG - TIS
18.01.2013 10:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
