1 Series E87 118d (M47T2) 5-door
Important!
Never twist brake hose when installing it and avoid all contact
with parts attached rigidly to the body.
Note:
First tighten brake hose on brake calliper.
Insert brake hose in bracket and screw onto brake pipe.
Pull brake pad wear sensor towards rear out of lining (right side
only).
If necessary, replace brake pad wear sensor.
Unscrew guide bolts (1).
If necessary, grip at hexagon head (2).
Remove brake calliper by pulling forward.
Installation:
Replace guide screws.
Tightening torque 34 21 5AZ
.
RA Removing and installing or replacing rear left or right brake calliper (TRW)
BMW AG - TIS
18.01.2013 10:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
