1 Series E87 118d (M47T2) 5-door
Preparation of new part:
Mark new part in accordance with severance cut on car and cut.
Open weld joints in areas (1) on both sides.
Open weld joints in area (2).
Detach remainder of reinforcement from engine carrier.
Installation:
Adjust new parts to fit with straightening attachment or universal
mount.
Installation:
Vehicles with spring support plate insert:
Different plate inserts are fitted, depending on the model.
•
Version (A) riveted or glued
•
Version (B) screwed
Important!
Use only identical plate inserts on both sides of the vehicle.
Riveted version:
If damaged, the plate inserts must always be replaced with glued
versions on both sides of the vehicle.
Glued version:
Adhesive/contact surfaces of plate insert must be free of sealing
compound, final paint coat and underseal.
Do not grind off KTL coating.
Read and comply with General cementing instructions.
Use adhesive gun 41 3 102 in conjunction with Sikaforce-7888
adhesive (sourcing reference: BMW Parts Service).
Apply adhesive in areas (1). Do not apply any adhesive in area
(2).
Secure plate insert with 3 screws and nuts for 2 hours at min. 20
°
C.
Important!
RA Replacing front section of engine support to left wheel arch
BMW AG - TIS
18.01.2013 11:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
