1 Series E87 118d (M47T2) 5-door
Important!
Do not damage bumper trim when pulling off.
Slide special tool 00 9 317 between bumper trim (1) and
bracket (2).
Release catches in area (3) and lever out bumper trim (1) in
outward direction.
Pull bumper trim (1) forwards a little.
If necessary, disconnect plug connections on ultrasonic sensors
and/or front fog lamps.
If necessary, unlock and detach hose for headlight cleaning
system.
Remove bumper trim (1) towards front with aid of a 2nd person.
Installation:
Catches (2) of bumper trim (1) must not be damaged.
Height adjustment, refer to Gap dimensions, body.
Replacement:
•
Remove centre radiator grille
•
Remove radiator grille for bumper trim
•
Remove body mouldings
Depending on version:
•
Remove number/license plate.
•
Remove holder for license plate.
•
Remove spray nozzles
•
Remove fog lamp
RA Removing and installing (replacing) front bumper trim (from 03/2007)
BMW AG - TIS
18.01.2013 11:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
