1 Series E87 118d (M47T2) 5-door
Note:
The following work must be carried out with a second person
assisting:
Snap out bumper trim (1) first at side left/right, then snap out
towards rear.
If necessary, disconnect plug connection for ultrasonic
transducer (3).
Feed out remaining cables and remove bumper trim (1) towards
rear.
Installation:
Make guides (2) are correctly seated.
Installation:
Catches (1) must not be damaged
If necessary, replace faulty sheet nuts (4) on left/right.
Replacement:
Remove ultrasonic transducer (2) .
Unscrew holder (3).
RA Removing and installing/replacing rear bumper trim (upper section) (M Technic ae
BMW AG - TIS
18.01.2013 11:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
