1 Series E87 118d (M47T2) 5-door
51 47 490
Removing and installing / replacing front
underbody protection
Note:
Description is shown on the E87 by way of example. There may
be differences in detail in the case of other models.
Release screws (1).
Pull underbody protection (2) forward under bumper trim (3).
Installation:
Centre underbody protection (2) and tighten down screws (1).
Replacement:
•
If necessary, modify or replace front section (1) of
underbody protection
•
Modify sheet nuts, replace defective nuts if necessary
RA Removing and installing / replacing front underbody protection
BMW AG - TIS
18.01.2013 12:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
