1 Series E87 118d (M47T2) 5-door
Note:
Lower instrument panel trim partially shown.
Detach left footwell heating duct (1) in area (2) in direction of
arrow.
Detach left footwell heating duct (1) with adapter (3) from
heater/air conditioner and remove in direction of arrow from left
rear compartment heating duct (4).
Installation:
Make sure retainer (2) is correctly seated on left/right footwell
heating duct (1).
Insert footwell heating duct (1) with adapter (3) in rear
compartment heating duct (4).
Attach footwell heating duct (1) in area (4) to heater/air
conditioner. Make sure assembly is locked exactly at point (5).
Unclip refrigerant line (3).
Feed out rubber grommet (4).
Installation:
Make sure rubber grommet (4) is correctly seated.
Important!
Carefully blow through aluminium triple pipe to remove
remaining coolant from heat exchanger for heating system.
Installation:
Vent cooling system and check for leaks.
Necessary preliminary tasks:
•
Disconnect all necessary cable ties on support tube.
•
Release wiring harnesses/cable ducts and lay to one side.
•
If necessary, remove control units/disconnect plug
connections.
Installation:
Make sure wiring harnesses/cable ducts are correctly routed and
secured.
RA Removing and installing/replacing heater
BMW AG - TIS
18.01.2013 14:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -