1 Series E87 118d (M47T2) 5-door
•
Door opened
•
Vehicle unlocked at driver's door lock cylinder
•
Vehicle unlocked with remote control
•
Terminal R OFF, if terminal 58g was ON no more than 2 minutes earlier
•
Crash signal
•
Lock button on remote control pressed when central locking system has been in central double-locking for at
least 10 seconds
The interior lighting is switched off under the following conditions:
•
Central locking system set to thiefproof mode, all doors and the tailgate closed
•
Interior lighting button pressed for longer than 3 seconds
•
Terminal 58 ON and terminal R OFF
•
Terminal R ON with doors closed
•
The vehicle is unlocked with the remote control and no door is opened with the space of 20 seconds
•
Terminal R OFF and a car door left open for longer than 1 minute
•
"Power Down" via diagnosis
•
8 minutes after terminal R OFF
When terminal R is switched OFF, the footwell module (FRM) will switch the interior lighting off after 8 minutes. To do
this, the footwell module sends the message for consumer shutdown via the K-CAN. The roof control panel (FZD)
receives this message and switches off the interior lighting in the roof area. Interior lights that are switched on directly
by the footwell module are also switched off.
The footwell module makes terminal 58 g available via K-CAN or via conventional wiring. Terminal 58 g is pulse-
width modulated and has two brightness levels.
-
Brightness level for locating lights
The brightness for the locating lights can be set individually with the rocker switch on the steering-column stalk.
-
Brightness level for function lighting
The brightness level for function lighting is not dimmed and is switched on at full intensity.
As soon as the hazard-warning lights switch is pressed, the lighting in the hazard-warning lights switch is switched on
at full intensity by the footwell module. If terminal 58 g is activated, the hazard-warning lights switch will no longer be
illuminated with full intensity. Brightness depends on the setting for the locating lights.
Notes for service staff
The following information is available for service staff:
-
General information: ---
-
Diagnosis: ---
-
Encoding/programming: ---
-
Nearly all Car and Key Memory functions are programmed inside the vehicle itself. (please refer to the "Personal
profile" section in the Owner's Handbook: Individual settings for up to 3 remote controls via the display in the
instrument cluster or via the Central Information Display)
Subject to change.
SBT Footwell module E70, E71, E81, E82, E87, E90, E91, E92, E93
BMW AG - TIS
18.01.2013 18:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
