bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

1 RA Replacing Engine Wiring Harness (N43)|Page 520 > < 1 RA Replacing Battery Positive Lead (between Jump-start Connection Point, Alternator|Page 517
Page 1
background image

12 51 001

Replacing engine wiring harness (N43)

Necessary preliminary tasks:

Read out fault memory of DME control unit

Switch off ignition

Disconnect battery

Remove microfilter housing

Remove acoustic cover

Remove intake air manifold

Remove intake duct

Important!

Read and comply with notes on protection against
electrostatic discharge (ESD protection).

Unlock fasteners (1) from below and slide upwards approx.
10 mm.

Unlock locks (2) in direction of arrow.

Remove cover (3).

Unlock and raise control unit (1).

Unlock plug (3) and remove.

RA  Replacing engine wiring harness (N43)

BMW AG - TIS

19.01.2013  17:35

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

1 RA Replacing Engine Wiring Harness (N43)|Page 520 > < 1 RA Replacing Battery Positive Lead (between Jump-start Connection Point, Alternator|Page 517