1 Series E87 118i (N43) 5-door
65 77 720
Removing and installing (replacing) left B-
pillar sensor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Warning!
Note airbag safety instructions!
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
•
Remove luggage compartment floor trim
•
Disconnect battery negative lead and cover
•
Remove trim panel for door pillar (bottom)
Release screw (1).
Loosen screw (2).
Installation:
Tightening torque 65 77 5AZ
.
If necessary, remove B-pillar sound insulation (5).
Raise B-pillar sensor (3) slightly through opening in B-pillar and
feed out towards rear.
Unfasten plug connection (4) and disconnect.
Remove B-pillar sensor (3) from B-pillar.
RA Removing and installing (replacing) left B-pillar sensor
BMW AG - TIS
20.01.2013 00:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -