1 Series E87 118i (N46) 5-door
Note different version of screws (1 to 3).
Fit cylinder head cover and install all screws still without
pretension.
Replace sealing element (1) and coat sealing surface with oil as
antiseize agent.
Fit sealing element (1) and install screws still without pretension.
Make sure gasket is correctly seated on cylinder head at front.
Note:
Illustration with engine removed.
Make sure gasket is correctly seated on cylinder head at rear.
Align cylinder head cover.
Tighten down all screws in diagonal sequence from inside
outwards.
RA Removing and installing/sealing cylinder head cover (N42/N46)
BMW AG - TIS
20.01.2013 10:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -