1 Series E87 118i (N46) 5-door
Insert bearing bracket nut on exhaust side and install without play.
Tighten bearing bracket nuts from inside outwards to initial torque
of 5 Nm and then tighten down to 10 Nm.
Remove special tool 11 9 310 from oil line and feed out from
intermediate lever.
Relieve tension on knurled screw (2) on special tool 11 9 301 .
Release screw (1) and remove special tool 11 9 301 .
Release special tool 11 9 303 .
Remove special tool 11 9 302 from bearing bracket (1).
RA Removing and installing/replacing intermediate levers (N42/N46)
BMW AG - TIS
20.01.2013 10:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -