1 Series E87 118i (N46) 5-door
Lever out spring (1) with a screwdriver from lug (2) on housing.
Tilt spring (1) upwards.
Remove bearing pin (1).
Installation:
Grease bearing pins (1).
Grease:
Refer to Service Operating Fluids.
Detach plug (1) from reverse gear switch.
Detach cables from fixtures on transmission.
Support transmission with workshop hoist.
Unfasten screws.
Tightening torque 23 00 1AZ.
Pull transmission downwards and remove.
Important!
Do not allow transmission to hang on transmission input shaft
when removing and installing, as the clutch disc will be
deformed.
RA Removing and installing transmission (S5D 250G)
BMW AG - TIS
20.01.2013 11:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
