Removing and Installing Eccentric Shaft for BMW E87 118i N46T Engine
Insert bearing shells (1) into bearing caps so that they are
secured in bore (2).
Lubricate bearing shells (1) with engine oil.
Note:
Lubricate eccentric shaft at bearing positions.
Replace needle bearing (1).
Important!
Needle bearings break off very easily when installed.
Carefully press needle bearings (1) apart at split position only to
such an extent that they can be fitted over eccentric shaft.
Insert eccentric shaft (1).
Note:
Bearing caps of eccentric shaft are marked E1 to E4 from inlet
side.
Lubricate bearing shells of bearing caps.
Fit bearing caps of eccentric shaft.
RA Removing and installing/replacing eccentric shaft (N46T)
BMW AG - TIS
21.01.2013 03:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
