1 Series E87 120d (M47T2) 5-door
Supporting transmission:
Support with special tools 24 5 306 , 24 5 301 and 00 2 030 .
Set up special tool 24 5 306 :
-
All supports to "A".
-
Supports 3 and 4 are at rear of transmission.
-
Support lettering points forwards.
Unfasten screws (1) and nuts (2).
Remove transmission cross-member.
Tightening torque 24 71 1AZ/2AZ
.
Release bolts (3) and remove exhaust system bracket.
Lower engine towards rear, lock between oil sump and steering
with a suitable block (1) or workshop jack.
Release screw (1).
Disconnect hydraulic lines (2) to transmission fluid cooler.
Installation:
Replace sealing rings.
RA Removing and installing automatic transmission (6HP19Z) M47T2
BMW AG - TIS
21.01.2013 22:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
