1 Series E87 120d (M47T2) 5-door
84 10 050
Removing and installing (replacing) USB hub
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove left front seat
•
Remove front left entrance cover strip
•
Fold back carpet for passenger compartment at front left in
direction of travel
Remove USB hub protective socket (1) from footwell insert (2).
Unlock catches (3) with a suitable tool and remove USB hub
protective socket cover (5).
Installation:
Make sure USB hub protective socket cover (5) engages
correctly on USB hub protective socket lower section.
Seal (4) must not be damaged; if necessary, replace USB hub
protective socket cover (5).
Remove USB hub (1) from USB hub protective socket lower
section (2).
Installation:
Make sure rubber grommet (4) is correctly seated on USB hub
protective socket lower section (2).
Disconnect plug connection (3).
RA Removing and installing (replacing) USB hub
BMW AG - TIS
22.01.2013 03:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -