1 Series E87 120d (N47) 5-door
Release control sensor (1) with special tool 11 7 020 .
Installation:
Threads of new oxygen sensors are already coated with
Never Seez Compound.
If an oxygen sensor is reused, only apply a thin and uniform
coat of Never Seez Compound (refer to BMW Parts
Service) to thread.
Oxygen sensor section projecting into exhaust system branch
must not be cleaned or come into contact with lubricant.
Pay attention to cable routing of oxygen sensors.
Use special tool 11 7 020 to tighten down oxygen sensor.
Tightening torque 13 62 3AZ
.
Cover oxygen sensors when applying underseal.
Installation:
Check stored fault messages.
Now clear the fault memory.
RA Replacing control sensor (N47)
BMW AG - TIS
22.01.2013 14:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -