1 Series E87 120d (N47) 5-door
32 41 060
Removing and installing (replacing) vane
pump for power steering (N47)
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove belt pulley
•
Remove front underbody protection
•
Remove radiator seal
Release banjo bolt (1) and disconnect pressure line (2).
Installation:
Replace all sealing rings.
Make sure pressure line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 8AZ
.
Release hose clamp (3) and detach suction line (4) from vane
pump.
RA Removing and installing (replacing) vane pump for power steering (N47)
BMW AG - TIS
22.01.2013 15:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -