1 Series E87 120d (N47) 5-door
67 62 000
Removing and installing/replacing flat motor
for front left or right power window unit
Necessary preliminary tasks:
•
Remove power window unit in front door
Release screws (1).
Tightening torque 67 62 1AZ
.
Detach flat motor for power window unit (2) from power window
unit and remove.
Installation:
Fit flat motor for power window unit (2) exactly on teeth of power
window unit.
Carry out function check (one-touch function, anti-trapping
protection and, if necessary, comfort function).
Replacement:
A normalization must be carried out in order to activate anti-
trapping protection.
Operating sequence for normalization:
•
Operate corresponding power window switch in "Close"
setting.
•
Once the upper end position has been reached, hold power
window switch down for approx. 1 second more.
Normalization is thus completed.
RA Removing and installing/replacing flat motor for front left or right power windo
BMW AG - TIS
22.01.2013 21:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -