1 Series E87 120i (N43) 5-door
Tighten down screw.
Tightening torque 13 53 5AZ
.
Connect contact plug (1) to low-pressure sensor (2).
Important!
Only if high-pressure rail has been replaced:
Slacken off nuts of delivery lines by 90
°
in illustrated sequence
and then retighten:
•
Tightening torque 1, 2, 4 and 5:
13 53 9AZ
•
Tightening torque 3:
13 53 10AZ
Connect fuel line (1).
Check fuel system for leaks.
Assemble engine.
Check function of DME.
RA Removing and installing or replacing high-pressure rail (N43)
BMW AG - TIS
23.01.2013 07:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -